20hp Portable Laser Water Chiller Modular Plate Heat Exchanger Condenser

Laser cutting machine water chiller failure possible causes:

The inlet end of the pipeline is blocked and air is inhaled;

Reverse connection of import and export pipeline;

Pump motor reversal or motor and pump shaft wear;

The oil used does not conform to the specifications or the level of the oil tank is lower than the lower limit;

The oil-water filter is blocked or the oil-water floating pressure ball is faulty;

Laser cutting machine water chiller fault solution:

Check and clean the oil circuit and tighten the pipeline;

Check that the import and export directions are correctly connected;

Updating the pump motor; Switch the red and white lines under the cumulative thermoelectric relay (51P);

As described in the instruction manual, select the compound oil and check whether the liquid level of the oil tank is normal;

Try to replace or clean the filter and try to replace the pressure float detection switch.